Advertisement
.To remove the battery cartridge, pull out
the
set
plate on the tool and grasp both
sides of the cartridge while withdrawing
it
from the tool.
* T o insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the tool to prevent the battery car-
tridge from accidentally falling out of the
tool.
Do not use force when inserting the battery cartridge. If the cartridge does not slide in
easily,
it
is not being inserted correctly.
Set plate
Battery cartridge
Charging
Your new battery cartridge is not charged.
You will need to charge it before use.
Use the fast charger Model DC1201 to
charge the battery cartridge.
.Plug the fast charger into the proper A/C
voltage source. The charging light will
flash in green color.
.Insert
the battery cartridge so that the
plus and minus terminals on the battery
cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so that
it
rests on the charger port floor.
When the battery cartridge i s inserted, the charging light color will change from green
to red and charging will begin. The charging light will remain lit steadily during charging.
When charging is completed, the charging light color will change from red to green and
a tone will sound steadily for about
5 seconds.
After charging, unplug the charger from the power source. Refer to the table below for
the charging time.
1200
DC1201
Approx.
45 min.
I
1201
I
ADDrox.
60 min.
I
6
Advertisement
