Ford Expedition 2000 Workshop Manual page 2

2000 Expedition/Navigator Workshop Manual
Item
Motorcraft Silicone Gasket Remover
ZC-30
Motorcraft Metal Surface Prep
ZC-31
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
Instant Adhesive
E8AZ-19554-A
SAE 5W-20 Premium Synthetic Blend Engine Oil
XO-5W20-QSP or equivalent
Motorcraft Premium Engine Coolant
VC-4-A (in Canada CXC-10; in Oregon VC-5) or
equivalent. Do not mix coolant types.
Motorcraft Premium Gold Engine Coolant
VC-7-A (in Oregon VC-7-B) or equivalent. Do not mix
coolant types.
Hydraulic Chain Tensioner Retaining Clip
Installation
All cylinder heads
1. CAUTION: The gasket sealing surfaces on the cylinder head and cylinder block must be clean. For additional information, refer to
Heads — 5.4L in the Removal portion of this section.
CAUTION: The use of sealing aids (aviation cement, copper spray, and glue) is not permitted. The gasket must be installed dry.
CAUTION: The new gasket has a film coating which is crucial to the gasket's ability to seal properly. Do not scratch the gasket.
NOTE: The RH head gasket is shown; the LH head gasket is similar.
Install the head gasket over the dowel pins.
2. CAUTION: Cylinder head machining or milling is not authorized by the Ford Motor Company. Cylinder head flatness must be within 0.0254 mm
(0.001 in) across a 38.1 mm (1.5 in) square area.
CAUTION: The gasket sealing surfaces on the cylinder head and cylinder block must be clean. For additional information, refer to
Heads — 5.4L in the Removal portion of this section.
CAUTION: The use of sealing aids (aviation cement, copper spray, and glue) is not permitted. The gasket must be installed dry.
CAUTION: Do not allow the dowels to scratch the sealing surface of the cylinder head during cylinder head installation.
NOTE: The new cylinder head bolts must be lightly oiled with a rag, and allowed to drain for a few minutes prior to installation.
NOTE: The RH cylinder head is shown; the LH cylinder head is similar.
Install the cylinder head on the dowels and the head gasket. Loosely install new bolts.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYJ/~MUS~LEN/21/S...
Specification
—
—
WSE-M4G323-A4
WSK-M2G402-A4
WSS-M2C153-H
ESE-M97B44-A (green in
color)
WSS-M97B51-A1 (yellow
in color)
1L3Z-6P250-AA
Page 2 of 20
Cylinder
Cylinder
1/19/2011