Advertisement
Tele Eye
III+
I
VX
Installation of Hard Disk
If you want to change the hard disk of
installation procedure.
recommended that you use the hard disk listed at the end of this section.
Procedures:
1.
Remove the hard disk rack as illustrated in the following diagram
2.
Open the cover of the hard disk cartridge provided by
cable and a 80-pin IDE cable
3.
Plug the power cable and the 80-pin IDE cable to the hard disk, and insert the hard disk
into the rack
4.
Fix the position of hard disk on the rack by fasten the screws
5.
Cover the hard disk rack, and insert the hard disk into
6.
Lock the Key Lock. Configure the
previous sections, and then switch the power on
Hard Disk Installation and Formatting
nstallation Guide
HARD DISK INSTALLATION
Tele Eye
III+
Step 1
Eject Hard Disk
AND FORMATTING
Tele Eye
III+
VX support ATA standard hard disk, it is highly
Step 2
Tele Eye
III+
SECTION
VX, you need to do the hard disk
Step 3
Tele Eye
, you will see a power
Tele Eye
III+
VX
VX with local display as described in
Page 33
5
Advertisement
