Table of Contents
Advertisement
Initial settings
When the TV is first turned on, it enters the initial setting
mode, and the JVC logo is displayed. Follow the
instructions on the on-screen display to make the initial
settings.
1 Press the #
# button on the remote control
#
#
The receiver power lamp changes from red to green.
After a short interval the TV power lamp lights green
and the JVC logo is displayed.
• Check that the AC plugs on the power cords from the
TV and receiver are connected to AC outlets.
Display front
<PD-42DX>
Remote control sensor
Power lamp
Receiver front
A button
• If the power lamp stays red and does not change to
green:
Your TV is in the standby mode. Press the #
(Standby) button again to turn your TV on.
• The JVC logo does not appear when your TV has
been turned on once. In this case, use the
"LANGUAGE" and "AUTO PROGRAM" functions
to make the initial settings. For details, see
"INSTALL" on page 34.
2 Press the a
a button
a
a
The LANGUAGE menu appears.
14
<PD-35DX>
Power lamp
Remote control
sensor
Power lamp
3 Press the 5
5 and 6
6 buttons to choose
5
5
6
6
ENGLISH. Then press the a
English is set for the on-screen display description. The
TELETEXT LANGUAGE menu appears as a sub-menu
of the AUTO PROGRAM function.
4 Press the 6
6 buttons to choose the teletext
6
6
language group that corresponds to language
of teletext programme that you want to watch
Group
Languages
GROUP-1
Turkish, Hungarian, English, German,
French, Italian, Spanish, Portuguese,
Greek, Swedish, Finnish
GROUP-2
Polish, Serbian, Croatian, Slovenian,
Czech, Slovak, Rumanian, Hungarian,
German, French, Italian, Swedish,
Finnish
GROUP-3
Russian, Bulgarian, Lettish, Lithuanian,
Estonian, Ukrainian, Serbian, Croatian,
Slovenian, Czech, Slovak, English,
German
GROUP-4
Arabic, Czech, Slovak. Hungarian,
English, German, French, Italian,
Spanish, Portuguese, Swedish, Finnish
5 Press the a
a button to start the AUTO
a
a
PROGRAM function
The AUTO PROGRAM menu appears and received TV
channels are automatically registered in the Programme
numbers (PR).
• To cancel the AUTO PROGRAM function:
Press the b button.
After the TV channels have been registered in
the Programme numbers (PR), the EDIT menu
appears
• You can proceed to edit the Programme numbers
(PR) using the EDIT/MANUAL function. For details,
see "EDIT/MANUAL" on page 34.
• If you do not need to use the EDIT/MANUAL
function, go to the next step.
6 Press the a
a button
a
a
a
a button
a
Advertisement
Table of Contents
