Advertisement
Valentine_308
I want to play a videotape in the Samsung Multi-standard VCR.
The VCR installed in this room will accept and play back 1/2" VHS NTSC, PAL, and SECAM videocassettes
through the LCD projector.
1. Power up the LCD projector with the RED "On-Off" button located Eiki remote control.
NOTE: Make sure the remote control power switch (left hand side) is in the 'on' position.
2. Press the VIDEO button on the projector remote control to switch the projector to the computer
input.
NOTE: Wait for the projectors countdown timer to expire before attempting to switch the input. The LCD
projector will take approximately one minute to warm up.
3. Power on the Samsung VCR with the power button located on the left side of the unit.
4. Press the NTSC button located to the right of the front display panel.
5. Insert the videotape into the VCR.
6. Turn on the audio amplifier with the "Standby/On" switch located on the left side of the unit. Select
the "VCR" input (input A) on the Yamaha audio amplifier and adjust the volume knob.
NOTE: For troubleshooting assistance, see the
2 of 9
"Adjusting Audio FAQ's"
9/2/03
section of this guide.
2:44 PM
Advertisement
