License Plate Lamp; Replacement Bulbs - Chevrolet 2010 Tahoe Owner's Manual

License Plate Lamp

1. Remove the two screws holding each of the
license plate lamps to the molding that is part of
the liftgate.
2. Twist and pull the license plate lamp forward
through the molding opening.
6-60
3. Turn the bulb socket counterclockwise and pull the
bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license
plate lamp.

Replacement Bulbs

If your vehicle is a Two-mode Hybrid, see the
Two-mode Hybrid manual for more information.
Exterior Lamp
Back-Up Lamp
License Plate Lamp
Rear Turn Signal Lamp, Taillamp, and
Stoplamp
For replacement bulbs not listed here, contact your
dealer.
Bulb Number
7441
W5W
3057