Advertisement
Warning: Make sure power is off and locked at the service disconnecting
7) Install an appropriate 1/2" UL listed electrical wire clamp through each motor box electrical opening on the top of the
liner. Install electrical wiring from the service panel to the liner location for each motor box. Consult the connection
diagrams (above) for further details on electrical placement.
Model
T200 Island Dual
T400 Island Cluster
* Add 0.5 amp for each halogen light.
• Because the Magic Lung
blower uses centrifugal filtration rather than conventional baffle or mesh filters, the Magic Lung
®
efficiently than other than other filtration systems. When comparing the Magic Lung
Ratings in accordance with the Standard Test Code by the Energy Systems Laboratory of the Texas Engineering Experiment Station.
#
8) Extend wires to the liner and insert them into the electrical wire clamp on each motor box. Tighten the wire clamp(s).
From inside the liner, using UL listed wire nuts, attach the "neutral" wire(s) to the white lead(s), the "hot" wire(s) to
the black lead(s), and the ground wire(s) to the green lead(s) inside the motor box(es).
Warning: Do not operate hood without proper ground connection.
9) Install transition in the exhaust collar(s). Seal connection with duct tape. Note: The transition must engage inside the
exhaust collar. While aligning the duct connection and guiding the wires, lift the liner up into the enclosure flushing
the bottom edges of the liner and the enclosure. Duct and transition should connect together as the liner is raised into
place. Wood strips may be necessary to fill any gaps between the opening and the liner if the opening in the wood
surround is larger than the liner.
10) Install a wood screw with a countersunk washer and a flat
washer into each mounting hole along the bottom edge of the
liner. Note: The hardware used in this step can be found in the
liner trim kit that was previously removed from the packaging
in Step 4.
11) Install the trim piece for the back and front of the liner (provided
in the liner trim kit) by hooking one side under the bottom
edges of the back countersunk washers. Snap the trim piece
over the top of the countersunk washers by applying pressure
upward and toward the liner wall. Repeat this process for the
side trim pieces (provided in the liner trim kit). Note: It may be
necessary to lightly tap the trim piece with a rubber mallet.
12) Plug the motors into the liner and reinstall the blower motor retaining screws that were previously removed in Step
6. Note: The side of the motor box where the "black" motors mount is labeled to ensure the motors are installed back
into the hood in the proper position.
13) Replace the blower housings and the blower shields. Make sure that the dampers open and close smoothly.
14) Refer to the Owner Maintenance Guide Operating Instructions for proper hood operation. Test all blower and light
functions to ensure they are operating properly.
L116 1213A
Installation Details Continued
means on the service panel during installation.
Volts
Amps*
Hz
115
2.9
60
115
5.8
60
with other blower units made by other manufacturers, use the "Equivalent CFM".
®
CFM
Equivalent CFM •
RPM
SP@0.0"
1550
550
900
1550
1100
1800
blower can handle cooking equipment with higher cubic feet per minute (CFM) requirements and can deliver equivalent CFM much more
®
Trim Piece
Page 5
CFM
CFM
CFM
SP@0.1"
SP@0.2"
SP@0.3"
507
471
431
998
855
774
Liner Trim Kit
Flat Nylon Washer
Wood
Screw
Countersunk
Nylon Washer
Minimum Round
Sones
#
Duct Size
8" (50 in.
)
6.0
2
12" (13 in.
)
6.4
2
Advertisement
