Step 1 Connection - Panasonic Diga DMR-EX773 Operating Instructions Manual

1
STEP
Using a 21-pin Scart cable
≥You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (
≥You can enjoy high-quality viewing by connecting the unit to an RGB compatible television (
Required setting
"AV1 Output" in the Setup menu (
≥Before connection, turn off all equipment and read the appropriate operating instructions.
≥Select the connection pattern that matches your environment from pattern A–B. Confirm connections not listed below with your
dealer.
≥Refer to "Additional connections" (
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power, even when it is turned off
[approx. 0.3 W ("Power Save in Standby" is activated and "RF OUT ( Aerial Signal )" is set to "Off".)]
A
Connecting a television
To the aerial
Aerial cable
RF coaxial cable
2
1 2
(included)
B
Connecting a television and digital satellite receiver
To the aerial Television's rear panel
Aerial cable
RF coaxial cable
(included)
2
RF
IN
RF
OUT
Digital satellite receiver's rear
panel
Required setting
"AV2 Input" setting in the Setup menu (
VQT2J39
8
Connection
63)
66) for connection using other terminals and connection with other equipment.
Television's rear panel
VHF/UHF
AV
RF IN
RF
IN
VIDEO
L
R
RF
OUT
AUDIO
OUT
VHF/UHF
AV
RF IN
VIDEO
L
R
AUDIO
OUT
21-pin Scart cable
AV
64)
Connecting a terminal other
than the 21-pin Scart terminal
( 9, 66)
3
Fully wired 21-pin
Scart cable
AV1
(TV)
AV OUT
OPTICAL
DIGITAL AUDIO OUT
AV2
(PCM/BITSTREAM)
(EXT)
Connecting a terminal other
than the 21-pin Scart terminal
( 9, 66)
Fully wired 21-pin
Scart cable
AV1
(TV)
AV OUT
OPTICAL
AV2 DIGITAL AUDIO OUT
(PCM/BITSTREAM)
(EXT)
Connect the unit directly to the television
If you connect the unit through an AV selector or
video cassette recorder to the television, video
signal will be affected by copyright protection
systems and the picture may not be shown
correctly.
≥When connecting to a television with a built-in VCR
Connect to the input terminals on the television side if there are both
television and VCR input terminals.
34).
79).
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
Cooling fan
This unit's rear panel
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
Cooling fan
AC IN
This unit's rear panel
4
AC IN
DO NOT
Television
VCR
This unit