Table of Contents
Advertisement
Sending the same document
to pre-programmed parties
using the auto document
feeder
{BROADCAST}
{<} {>} {+} {-}
{STOP}
1
Confirm that there are no documents on the
scanner glass.
Insert the document FACE DOWN into the
feeder.
L If necessary, press {RESOLUTION}
repeatedly to select the desired
resolution (page 35).
2
Press {BROADCAST}.
L You can also use the navigator key.
Press {<} or {>}, then press {+} or
{-} until the following is displayed, and
press {SET}.
L The document will be fed into the unit
and scanned into memory. The unit will
then transmit the data to each entry,
calling each number sequentially.
L After transmission, the stored document
will be erased automatically, and the
unit will automatically print a broadcast
sending report.
{RESOLUTION}
{SET}
{FAX/START}
<BROADCAST>
b
SEND:PRESS SET
EDIT:PRESS MENU
Sending Faxes
Note:
L Do not open the document cover while
sending a fax with the auto document feeder.
L If you select "FINE", "SUPER FINE" or
"PHOTO" resolution, the number of pages
that the unit can transmit will decrease.
L If the document exceeds the memory
capacity, sending will be cancelled.
L If one of the entries is busy or does not
answer, it will be skipped. All skipped entries
will be redialled up to 5 times after all of the
other entries have been called.
To send the same document to more than
one party only once
You can also select the parties for each
transmission.
1. Insert the document.
2. Press {>}.
3. Press {+} or {-} until the following is
displayed.
4. Press {SET} to start programming the
entries you want to transmit to.
5. Press {+} or {-} until the desired entry you
want to transmit to is displayed.
Example:
6. Press {SET}.
Example:
L To program other entries, repeat steps 5
and 6 (up to 20 entries).
7. Press {SET} to start transmission to the
programmed entries.
<ONE TIME BROAD>
PRESS SET
DIR=
[00]
NAVI.[+ -] & SET
BILL
6543210
DIR=BILL
[01]
SEND:PRESS SET
43
Advertisement
Table of Contents
