Changing The Country Setting - JVC AV42PD20ES Instructions Manual

Changing the COUNTRY setting

After the AUTO PROGRAM function is completed, you
can change the country you have already set by using the
AUTO PROGRAM function.
When registering the TV channels for French broadcast
stations (SECAM-L system), perform this operation to
change the country.
1 Display the INSTALL menu
When the EDIT menu is currently being
displayed:
Press the h (Information) to return to the INSTALL
menu.
2 Press the 6 6 buttons to choose AUTO
6 6
PROGRAM. Then press the a
A COUNTRY menu appears as a sub-menu of the
AUTO PROGRAM function.
There are two COUNTRY menus. Pressing the yellow
button changes the COUNTRY as follows:
3 Press the 5 5 and the 6 5 5
country
4 Press the a a a button to complete the setting a
The menu disappears.
To return to the INSTALL menu from the
COUNTRY menu:
Press the h (Information) button instead of the a button.
Using the DECODER (EXT-2) function
When connecting a Decoder with a T-V LINK compatible
VCR connected to the EXT-2 terminal, use the DECODER
(EXT-2) function to unscramble the scrambled TV
channels.
1 Turn on the Decoder power
2 Display the TV channel capable of being
unscrambled with the Decoder on the TV
Even if the Decoder is functioning, a scrambled picture
appears at this time.
3 Press the a a button to display the MENU
a a
The MENU (main menu) appears.
4 Press the 6 6 buttons to choose FEATURES.
6 6
Then press the a a button
a a
The FEATURES menu appears.
a button a a
6 buttons to choose a 6 6
Additional menu operations
5 Press the 6 6 buttons to choose DECODER
6 6
(EXT-2). Then press the 5
ON
An unscrambled picture appears.
To cancel the DECODER (EXT-2) function:
Press the 5 buttons to choose OFF.
6 Press the a a button to complete the setting a a
The T-V LINK menu appears.
7 Follow the operating procedure "Downloading
the data to VCR" on page 28 to transmit the
programme number (PR) data to the VCR
8 If you have another TV channel capable of
being unscrambled with a Decoder, repeat
steps 2 to 7
If for some reason the DECODER (EXT-2) function has
been set to "ON" but the TV channel cannot be
unscrambled, check the following:
• Has the Decoder been connected to the VCR properly
according to the VCR and Decoder Instruction
Manuals?
• Has the Decoder power been turned on?
• Can the TV channel be unscrambled with a Decoder?
• Is it necessary to change the VCR settings in order to
connect the Decoder? Confirm that the VCR is set
properly by rechecking the VCR Instruction Manual.
5 buttons to choose
5 5
29