Advertisement
Battery Level Check and Monitor: Each time the pager is turned on, or the RESET
switch is pressed and released, the battery level is checked (refer to BATTERY
TEST and Figure 3.) If the battery voltage drops below a minimum level
(approximately 1.1 volts), an automatic low battery warning will be heard, which is a
one-second fast pulsating beep. The automatic warning is produced only once and
does not occur again until the
Page 10
pager is turned off, and then back on again. Once you hear this alert, you should
replace the alkaline battery within a few days. A rechargeable battery should be
replaced or recharged within a few hours.
Battery Information
Battery Types: The pager is designed to operate with a single AA-size alkaline
battery (Motorola type NLN8278) or a single, AA-size nickel-cadmium battery
(Motorola type NLN7975.) Either of these batteries provides for optimum pager
performance.
AA-size alkaline or nickel-cadmium batteries from other manufacturers may give
comparable performance, but have not been tested by Motorola. Substitution of a
battery other than those recommended by Motorola could reduce operating life.
Replacing the Battery
When necessary, replace the battery by fol-
Page 11
lowing the instructions listed in Step 2, under Battery Installation.
Options
your pager may be equipped with one or more of the following options. Contact your
Pager Service Company or manager for availability of these options.
External Speaker Jack: When a pager is used in a high noise environment, an
optional Motorola-approved lapel speaker or ear piece can be connected to the
external accessory jack located on the top control panel. The jack is fitted with a
protective plug.
Note: To prevent entry of dust and moisture, the plug should be inserted whenever
the external speaker jack is not being used.
Page 12
Fixed Alert/Audio Only Volume Control: When this option is installed, the alert tone
volume is factory preset (non-adjustable) at the maximum volume level. turning the
volume control will vary only the voice message volume level. Note: Use of earphone
is not recommended with this option.
Function 1 Voice/Function 2 Tone: The function 1 voice/function 2 tone pager
operates the same in function 1 as the standard tone-and-voice model. However,
when a function 2 page is received, a continuous alert tone is heard (no voice.)
Unless reset, the alert lasts for 12 seconds. The function 2 page contains no voice
message.
(image) and Motorola are registered trademarks of Motorola, Inc.
KeyNote is a trademark of Motorola, Inc.
Advertisement
