Setra Systems L Series User Manual page 14

7. Press the print key on the balance.
8. Repeat Steps 5, 6 and 7 anytime you wish to print out information.
NOTE: When using a printer other than the Setra 240P or 340P, set the baud rate
on your balance to match the printer (see Appendix I).
NOTE: To interpret the meaning of the symbols printed, see Appendix IV - "RS-232
Serial Data Communications."
REPETITIVE PRINTING
It is sometimes desirable to measure weight at fixed intervals of time. One use of this
procedure is evaporation studies. To print out weight at fixed intervals, follow this
procedure:
1. Connect a printer as previously outlined.
2. Enter the number of seconds between readings.
3. Press print. The balance will print out a reading at the specified interval.
4. To cancel repetitive printing, press — then print.
To interpret the meaning of the symbols printed, see Appendix IV - "RS-232 Serial Data
Communications."
NOTE: Since all Setra balances employ Auto Zero Tracking, it is important not to
perform evaporation or similar studies at zero. To disable Auto Zero
Tracking, enter an artificial tare weight. (For example, tare out 100g.) When
the study is completed, enter the negative of the tare weight.
INTERFACING WITH A COMPUTER
Your Setra balance is designed to interface with a wide variety of computer equipment.
If your balance is connected to a computer, transmit information to the computer by
following the instructions given for "Printing Out Information." For further details, see
Appendix IV.
14