Connecting The Base Station; Connecting The Charging Cradle (If Included) - Gigaset A120 User Manual

Setting up the base station and charging cradle (if included)
◆
Set up the base station at a central location on a flat, non-slip surface in your house or apartment. You can also
mount the base station and charging cradle on the wall.
◆
Pay attention to the range of the base station. This is up to 300 m in unobstructed outdoor areas and up to 50 m
inside buildings.
◆
The base station and charging cradle are designed for use in enclosed dry rooms in a temperature range of +5 °C to
+45 °C.
◆
Care: Wipe down the base station and handset with a damp cloth (no solvents) or an antistatic cloth. Never use a
dry cloth. This can cause static.
◆
The phone's feet do not usually leave any marks on surfaces. However, due to the multitude of different varnishes
and polishes used on today's furnishings, the risk of marks on the surfaces cannot be completely ruled out.
◆
Never expose the telephone to the influence of heat sources, direct sunlight or other electrical devices.
◆
Protect your Gigaset from moisture, dust, corrosive liquids and vapours.

Connecting the base station

¤
First connect the mains adapter
¤
Then connect the telephone jack
cable ducts.
Please note:
◆
The mains adapter must always be connected, as the phone will
not operate without mains connection.
◆
Use only the mains adapter and phone cord supplied. Pin connec-
tions on telephone cables can vary.
◆
The answering machine (A220A only) is ready for use approx.
30 seconds after the base has been connected.

Connecting the charging cradle (if included)

2
1
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable batteries recommended by Gigaset Communications GmbH (
conventional (non-rechargeable) batteries as this could result in significant health risks and personal injury. For
example, the batteries could explode. The phone could also malfunction or be damaged as a result of using batteries
that are not of the recommended type.
¤
Insert the batteries with the polarity
in the correct direction.
The polarity is indicated in the battery
compartment.
1
.
2
and insert the cables into the
¤
Connect the flat plug to the
power supply 1 .
¤
Plug the mains adapter into
2
the plug socket .
¤
¤
¤
3
If you need to disconnect the
plug from the charging cradle,
press the release button
disconnect the plug
First insert the battery cover at the top a.
Then press the cover
b
To reopen the battery cover, grip into the cavity on the casing,
then pull the battery cover in an upward direction.
2 1
3
and
4
.
¢
page 11), i.e. never use
until it clicks into place.
a
1 1
4
3
b