Connecting The Base Station; Connecting The Charging Cradle (If Included); Setting Up The Handset For Use - Gigaset a120 Instruction Manual

Connecting the base station

¤
First connect the mains adapter
1
.
¤
Then connect the telephone
2
jack and insert the cables
into the cable ducts.
Please note:
◆
The mains adapter must always
be connected, as the phone will
not operate without mains con-
nection.
◆
Use only the mains adapter and phone cord supplied. Pin connections on tele-
phone cables can vary.

Connecting the charging cradle (if included)

¤
Connect the flat plug to the power
2
supply
¤
Plug the mains adapter into the plug
1
socket
2 1
1 .
2 .
If you need to disconnect
the plug from the charg-
ing cradle, press the
release button 3 and
disconnect the plug 4 .
3

Setting up the handset for use

The display is protected by a plastic film. Please remove the protective film!
1 1
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable batteries recommended by Gigaset Communications
¢
GmbH ( page 10), i.e. never use conventional (non-rechargeable) batteries as
this could result in significant health risks and personal injury. For example, the
batteries could explode. The phone could also malfunction or be damaged as a
result of using batteries that are not of the recommended type.
¤
Insert the batteries with
the polarity in the correct
direction.
The polarity is indicated in the
battery compartment.
4
3
¤
First insert the battery cover at the top a.
¤
Then press the cover b until it clicks into
place.
¤
To reopen the battery cover, grip into the
cavity on the casing, then pull the battery
cover in an upward direction.
a
b