Power - JVC AV-32920 User Manual

Make sure that the TV/CATV switch is set to TV. Switch to CATV only if you plan to operate a cable box.
P ress the P button on the remote control or the TV front panel. The On Timer lamp will glow red.
O W E R
The first time you turn on the TV, the "Plug In Menu" will appear. You should turn to page 15 now
to learn more about this menu.
To turn the power off, press the P
The On Timer lamp remains on while the On/Off Timer function is active.
1
Press the V
OLUME
2
Press the M
UTING
previous level, press the M
1 10 key direct access.
Press the numbers on the remote's 10 key pad. For single-digit channel numbers press 0 then the
number. For channels above 100, press the 100+ button plus the 2-digit number.
2
C -/+ button.
HANNEL
Press the C -/+ button, it will scan the channels in order.
HANNEL
NOTE: After you operate the Auto Tuner Setup (page 15), all of the blank, or empty, channels will be
removed from scanning so that there is no noise or channel snow when you scan, only active channels.
3
Return.
Press and release the R
(game #1). Then, select another channel (game #2) with the 10 key pad and push the R
button to flip directly back and forth.
4 Return+ .
Press and hold down the R
PROGRAMMED !" will appear and you can scan as you wish. Press R
back to the Return+ channel.
To cancel a Return+ channel, press and hold down the R
and the message, "RETURN CHANNEL CANCELLED !" appears.
Pressing a number key or turning the set off will also cancel a Return+ channel.
G E T T I N G
button again. The On Timer lamp will go out.
OWER
button on the front panel or remote control. The volume slidebar will appear.
VOLUME 13
|||||||
button to instantly turn the volume off. To restore the volume to the
button again.
UTING
+ button to return to the previous channel. First, select a channel
ETURN
+ button for three seconds. The message, "RETURN CHANNEL
ETURN
S T A R T E D
-------------------
+ button for another three seconds
ETURN
ETURN
+ again and you will go
ETURN
1
1
+