Figure 21 Display With All Indicators Lit - Honeywell ST 3000 User Manual

5.3 Making Initial Checks,
Local smart meter
display indications
56 ST 3000 Release 300 and SFC Model STS103 User's Manual
You can check the status of all the indicators on the Local Smart Meter
LCD display by cycling power to the transmitter. The meter runs a brief
self-test whenever power is applied to the transmitter. All the display
indicators are lit during the self-test as shown in Figure 21.
Figure 21 Display With All Indicators Lit.
V A R
SEL.
SP AN
ZERO
Please refer to Table 31 in this manual for a description of the pushbuttons
on the meter face. See Section 8.6 for a description of the indicators with
examples of typical display indications and error codes. (Note that the
display may revert to dashes (– – –) after the self-test until the transmitter
initializes all its functions.) Use the SFC to check the transmitter's status.
Continued
%
0
18 8 8 0
-
. .
OUTPUT MODE ANALOG
CHECK STATUS
K
KNOWN VALUE
UPPE R
VALUE
100
UNITS
%
S E T
FLOW
In H O
2 LOWER
GPH mmHg VALUE
A
GPM PSI
February 2012