Panasonic KX-FP105BX Service Manual page 79

Error code table:
(1) CODE (2) RESULT
PRESSED THE STOP KEY
DOCUMENT JAMMED
NO DOCUMENT
THE COVER WAS OPENED
40 NO RESPONSE
41 COMMUNICATION ERROR
42 COMMUNICATION ERROR
43 COMMUNICATION ERROR
44 COMMUNICATION ERROR
46 COMMUNICATION ERROR
48 COMMUNICATION ERROR
49 COMMUNICATION ERROR
50 COMMUNICATION ERROR
51 COMMUNICATION ERROR
52 NO RESPONSE
54 ERROR-NOT YOUR UNIT
58 COMMUNICATION ERROR
59 ERROR-NOT YOUR UNIT
65 COMMUNICATION ERROR
65 COMMUNICATION ERROR
68 COMMUNICATION ERROR
70 ERROR-NOT YOUR UNIT
72 COMMUNICATION ERROR
75 MEMORY FULL
79 CANCELED
FF COMMUNICATION ERROR
TX=TRANSMISSION RX=RECEPTION
Most fax communication problems can be resolved by the following steps.
a. Change the transmit level. (Service code: 596, refer to 2.4.4. SERVICE FUNCTION TABLE.)
b. Change the TX speed/RX speed. (Service code: 717/718, refer to 2.4.4. SERVICE FUNCTION TABLE.)
Note*:
If the problem remains, see the following "Countermeasure" flow chart.
(3) MODE
TX & RX Communication was interrupted by the STOP button.
TX The document paper is jammed.
TX No document paper.
TX & RX The cover is open.
TX Transmission is finished when the T1 TIMER expires.
TX DCN is received after DCS transmission.
TX FTT is received after transmission of a 2400BSP training signal.
TX No response after post message is transmitted three times.
TX RTN and PIN are received.
RX No response after FTT is transmitted.
RX No post message.
RX RTN is transmitted.
RX PIN is transmitted (to PRI-Q).
RX PIN is transmitted.
RX Reception is finished when the T1 TIMER expires.
RX DCN is received after DIS transmission.
RX DCN is received after FTT transmission.
TX DCN responds to the post message.
TX DCN is received before DIS reception.
RX Reception is not EOP, EOM PIP, PIN, RTP or RTN.
RX No response at the other party after MCF or CFR is transmitted.
RX DCN is received after CFR transmission.
RX Carrier is cut when the image signal is received.
RX The document was not received due to memory full.
TX The multistation transmission was rejected by the user.
TX & RX Modem error. For the DCN, DCN, etc. abbreviations, refer to 6.6.
MODEM SECTION.
51
SYMPTOM
KX-FP101
Counter-
measure*
1
2
3
4
5
6
7
8
8
8
9
11
13
14
2
2
13
13
16
12