Jensen Elite-606 User Information

140 watt powered subwoofer

Table of Contents

Download this manual

Elite-606

140 Watt Powered Subwoofer

Congratulations on investing in one of JENSEN's finest Subwoofer

Systems. You will find this information valuable for the long term

enjoyment of your Elite-606 Sub.

Check for damage:

We know you will be eager to install your new Elite-606

Subwoofer, however, please firstly inspect your unit for any damage. If you find a problem

please contact us immediately at info@bdimports.com.au . Also, do not forget to Register

your 5 Year Warranty (1 Year on amplifier) Online by visiting www.jensenspeakers.com.au

Premium grade parts and materials are used in your Elite-606 products. Break

In period is appx 10-20 playing hours after which time Bass will deepen and tighten. There is no need to

limit playback volume at all during this time.

Table of Contents

Do you have a question about the Elite-606 and is the answer not in the manual?

Page 1 5 Year Warranty (1 Year on amplifier) Online by visiting www.jensenspeakers.com.au Break in Period Premium grade parts and materials are used in your Elite-606 products. Break In period is appx 10-20 playing hours after which time Bass will deepen and tighten. There is no need to...
Page 2 LED will change to Red. LOW LEVEL OUTPUT: Are provided for adding additional JENSEN Elite-606 using an additional 1RCA to 1 RCA lead. You may add as many JENSEN Elite-606’s as you like (see “For Big Bass Lovers” below). LOW LEVEL INPUT : Connect from your Multi Channel Receiver (5.1, 6.1 etc.
Page 3 Connect 1xRCA to 1xRCA lead (not supplied) from SUB-OUT on your Receiver to “LOW LEVEL INPUT on Elite-606 Subwoofer. Connect to either L or R as both are internally paralleled and make no difference. These leads are available in 1,3,5,10 and 20 meter lengths. Unlike speaker leads, you do not lose power by increasing lead lengths.
Page 4 Bass resulting in exponentially enhancing overall Sub-Bass performance. In this case 2 x JENSEN Elite-606’s will perform like 3. And 3 will perform like 5 etc. Switch them all to “AUTO” and they can all be left on indefinitely and activate together when an incoming signal is sensed. Front panel LED’s will all turn Blue and …...