Roland Quad-Capture Owner's Manual page 15

5. When a confirmation screen regarding user account control appears, click [Yes]
or [Continue].
6. When "The QUAD-CAPTURE Driver will be installed on your computer." appears,
click [Next].
7. Click [Next] again.
Windows 8.1/8/7/Windows Vista
If a dialog box regarding Windows security appears, click [Install].
Windows XP
If the "Software Installation" dialog box appears, click [Continue] to proceed with the
installation.
If you cannot proceed, click [OK] to cancel the installation. Change the settings as
described in "Driver Signing Options Setting (Windows XP)" (p. 44) and try installing again.
8. When "Ready to install the driver." appears,
connect the QUAD-CAPTURE to the
computer using the USB cable.
* Turn down the volume on any peripheral devices
before connecting the USB cable.
* This unit is equipped with a protection circuit. A
brief interval (a few seconds) after power up is
required before the unit will operate normally.
* Always make sure to have the volume level
turned down before switching on power. Even
with the volume all the way down, you may still hear some sound when the power is
switched on, but this is normal, and does not indicate a malfunction.
It may take several minutes for the driver to be installed.
Windows 8.1/8/7/Windows Vista
If other messages appear, follow the instructions on the screen. The driver will be installed
automatically.
Windows XP
"Found new hardware" will appear in the lower-right corner of the screen.
Windows 8.1/8/7/Windows Vista
Windows XP
users: continue to p. 17
Windows
users: continue to p. 16
Driver Installation
15