Cadillac 2011 Escalade EXT Owner's Manual page 36

2-6 Keys, Doors and Windows
To start the vehicle using the remote
start feature:
1. Aim the transmitter at the
vehicle.
2. Press and release . The
vehicle's doors will lock.
Immediately press and
hold until the turn signal
lamps flash. If you cannot see
the vehicle's lamps, press and
hold for two to four seconds.
Pressing again after the
vehicle has started will turn the
engine off.
When the vehicle starts, the
parking lamps will turn on and
remain on while the engine is
running.
If the vehicle is left running it
will automatically shut off after
10 minutes unless a time
extension has been done.
Ofrecido por www.electromanuales.com
3. If it is the first remote start since
the vehicle has been driven,
repeat these steps, while the
engine is still running, to extend
the engine running time by
10 minutes. Remote start can
be extended one time.
After entering the vehicle during a
remote start, insert and turn the key
to ON/RUN to drive the vehicle.
To manually shut off a remote start,
do any of the following:
Aim the RKE transmitter at the
vehicle and
lamps turn off.
Turn on the hazard warning
flashers.
Turn the ignition on and then
back off.
The vehicle can be remote started
two separate times between driving
sequences. The engine will run for
10 minutes after each remote start.
Or, you can extend the engine run
time by another 10 minutes within
the first 10 minute remote start time
frame, and before the engine stops.
For example, if
pressed again after the vehicle
has been running for five minutes,
10 minutes are added, allowing the
engine to run for 15 minutes.
The additional 10 minutes are
considered a second remote vehicle
start.
After the vehicle's engine has been
until the parking
started two times using
single remote start with one time
extension, the vehicle must be
started with the key.
After the key is removed from the
ignition, the vehicle can be remote
started again.
The vehicle cannot be remote
started if the key is in the ignition,
the hood is not closed, or if there
is an emission control system
malfunction and the malfunction
indicator lamp is on.
and then are
, or a