Operation - Makita BTS130 Instruction Manual

2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
2 3
1
011407
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
Hook
3
006592
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
1. Bit
2. Bit-piece
3. Sleeve
1. Screw
2. Hook
3. Groove
2
1

OPERATION

1
006843
CAUTION:
Never obstruct the air vents on the side of the tool
•
for cooling down oil unit and motor during operation.
Failure to do so may cause the tool excessive
hotness and damage.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
N m
(ft lbs)
30
(306)
20
(204)
M6
10
(102)
0
0.5
Fastening time (S)
006841
7
1. Air vents
2. Cooling down oil
unit
2
M10
M8
1.0