Backing Up The Firmware - Intel DK50 Series Getting Started Manual

Programming the SPI Flash Firmware
Figure 22. Programming Complete
9. Disconnect the USB cable from the Host System.
10. Disconnect the DediProg cable from the header on the Target System.
7.3

Backing Up the Firmware

Perform the following steps to make a backup copy of the firmware that is on the
micro-SD card.
1. Disconnect the power supply from the Target System.
2. Identify the 7-pin SPI header on the Target System. See the red arrow in the
figure below.
April 2014
Document Number: 330496-001
Intel® Gateway Solutions for the IoT DK50 Development Kit
Getting Started Guide
33