Intel DK50 Series Getting Started Manual page 17

Target System Setup

3. Start the SSH session between the Host and Target Systems:


Figure 10. SSH Terminal Configuration Using PuTTY*
April 2014
Document Number: 330496-001
Wired Ethernet Connection: If connected to the Target System through the
Wired Ethernet Interface, you can find the IP address of the Target
System in the DHCP Client Table of the router to which the Target and
Host systems are connected.
On a Linux Host System, issue the command:
<IP Address> is the IP Address of the Target System. You may need to
add sudo to your ssh command for admin access.
On a Windows or Linux Host System, use terminal software, such as
PuTTY, to connect to the Target System using the Target System's IP
Address. See the following figure.
Intel® Gateway Solutions for the IoT DK50 Development Kit
ssh <ip address>
§
where
Getting Started Guide
17