Intel DK50 Series Getting Started Manual page 30

3. Connect the DediProg to the Target System as shown in the figure below.
Figure 18. Connection from DediProg to Target System
4. Plug in the USB connection of the DediProg Flash Programmer to the Host PC.
The DediProg software must already be installed on the Host System. You will
see a pop-up message similar to the one shown below. Select W25Q64FV
and click OK.
Figure 19. Flash Memory Selection
Intel® Gateway Solutions for the IoT DK50 Development Kit
Getting Started Guide
30
Programming the SPI Flash Firmware
Document Number: 330496-001
April 2014