Table of Contents
Advertisement
Figure 6.
PuTTY Configuration Snapshot 2
If the PuTTY connection fails using the above settings, check for incorrect rd/wr/exe
permissions for the file handle /dev/ttyUSBn (where n is the device number that the
OS assigns. It is typically 0 through 9). Update the permission settings using the
chmod linux command. See the following figure.
Figure 7.
Confirm USB-Serial Device is recognized in Linux
Detailed instructions for connecting the serial port from the Target to the Host System
are in the Intel
Intel® Gateway Solutions for the IoT DK50 Development Kit
Getting Started Guide
12
®
Galileo Board Getting Started Guide.
Target System Setup
April 2014
Document Number: 330496-001
Advertisement
Table of Contents
