IMPORTANT SAFETY INSTRUCTIONS CAUTION! RISK OF ELECTRIC SHOCK DO NOT OPEN USE IN DRY LOCATIONS ONLY The lighting flash with arrowhead CAUTION: The exclamation point symbol, within TO PREVENT THE RISK OF ELECTRIC symbol, within an equilateral triangle, is an equilateral triangle, is intended SHOCK, DO NOT REMOVE COVER intended to alert the user to the presence to alert the user to the presence of...
CONTENTS Introduction..............4 About XTZ................ 4 Product information............5 Installation..............6 Calibration............... 9 Care of your speaker............11 Troubleshooting and service......... 11 Technical specifications........... 12 Service & support............13...
Introduction Introduction Congratulations on your purchase of XTZ loudspeakers. This product represents the state of the art in loudspeaker performance and will provide you with years of listening pleasure when properly setup and cared for. We strongly urge you to read this owner’s manual and follow the instructions provided to help you attain maximum system performance.
NOTE: Remember to make all equipment connections with system power disconnected to reduce the risk of personal shock or damage to equipment. Consult your dealer or info@xtz.se for optional accessories that may be required to properly complete your system installation.
General guidelines The M6’s are intended to be used as front Left, Right and Center channel, a so called LCR speaker. The LC and RC are mirror image speakers. Either can be used equally well as center channel. The M6 can of course also be used as surrounds or back channel speakers.
Page 7
Wall mounting The M6 has two key-hole type wall mounts integrated in the back baffle, see the figure below to the left. It also has five sets of threaded inserts to attach the mounting bracket of your your choice, all with a distance of 76 mm (3”) which are inted to be used with our Flush Mount Brackets, see figure here to...
Page 8
This macthing stand has the indentical matte black finish as the speaker and places the tweeter arrary at the recommended listening height. The M6 can be placed standing up as front left and right speaker and horizontal as a center speaker. The stand can also be used well with the...
Crossover frequency should be selected. We recommend 80Hz for the M6 to start. Slighly higher or lower xover point may yield better results in your system.
Page 10
Do not be afraid to experiment with slight adjustments to find what may improve the sound in your system and room the best! Do not hesitate to contact us at info@xtz.se for questions about settings. We are happy to assist you in optimizing your system!
Care of your speaker Your new speakers does not require any regular maintenance or calibration. Normal dusting or cleaning of the surface for appearance purposes is all that is required. Cabinet and baffle Avoid using harsh detergents or chemicals when cleaning the cabinet. Abrasives, detergents, or cleaning solutions may damage the finish on the cabinet.
Service & support ”Do It Yourself” - service We apply “do-it-yourself” service on all XTZ products. If you by yourself are able to find out what part To aid service, XTZ products are con- structed and produced using com- of the loudspeaker is defective, you are fully allowed to unmount that part (which would normally be a mon technology, so that basically driver, a filter or the amplifier) and send it back to us for exchange.