Advertisement
Quick Links
Advertisement
Related Manuals for Snell PS.10
Summary of Contents for Snell PS.10
- Page 1 PS.10 Powered Subwoofer Owner‘s Manual...
- Page 2 For all other servicing, con- its proper functioning. For example, the appliance sult your dealer or contact Snell Acoustics. should not be situated on a bed, sofa, rug, or simi- lar surface that may obstruct the heat sink sur-...
- Page 3 3,000 cubic-foot room, the PS.10 meets the demands of digital 5.1 formats. Easy to Hide Yet, the PS.10 is so compact, it easily fits within a The PS.10 cabinet is small enough to tuck behind typical AV cabinet.
- Page 4 F E A T U R E S...
- Page 5 The proper set- ting changes based upon the current location Bass Driver of the speaker. The PS.10 uses a 10-inch (250 mm) custom- built bass unit with dual spiders, a coated Power (Off/Auto/On) paper cone with butyl surround, and a die-cast Set to ”AUTO,“...
- Page 6 Most surround sound receivers and preamps now offer a ”SUBWOOFER OUT“ feature. When using this option, the subwoofer filter will most likely be set within the electronics. The signal being sent to your main speakers will be full range. You should then set the PS.10‘s internal crossover for ”EXTERNAL.“...
- Page 7 1. Use the line-level RCA inputs, connecting to ”PREAMP OUT“ on your receiver. 2. From the PS.10 line-level out, connect to ”AMPLIFIER IN“ on your receiver. 3. Choose a setting for the PS.10 crossover that allows the subwoofer to blend seamlessly with the main speakers.
- Page 8 The simplest way to wire the subwoofer is via the speaker connections. This does not present any additional load to your amplifier. The PS.10 is not sensitive to wire length, therefore you may want to use long wires at first to allow for experimentation with placement.
- Page 9 Option 2 Connect both the subwoofer and the main speakers to the back of the receiver. Option 3 Connect the amplifier to the main speaker system and the main speaker system to the subwoofer in.
- Page 10 Use "Y" connectors to daisy chain the ”PREAMP OUT“ signal to the input of a second PS. 1 0. Wiring two PS.10’s using speaker-level inputs Use the ”OUT TO“ binding posts on one subwoofer to daisy chain to the second PS.10.
- Page 11 P L A C E M E N T Subwoofers often are smoothest when placed snugly against a side or back wall. Placement in a corner gen- erally offers up the smoothest response. These positions will also increase the subwoofers‘ sensitivity, allow- ing you to run them at a reduced power.
- Page 12 L I M I T E D W A R R A N T Y For one year from the date of purchase, Snell Acoustics will repair for the original owner any defect in mate- rials or workmanship that occurs in normal use of the speaker system, without charge for parts and labor.