Breville Dual Boiler BES920 Instruction Booklet page 12

OPERATING yOUR BREvILLE PROdUCT
Step 3 – Begin de-scale
NOTE
If water tank has not been removed
then replaced or is empty, water tank
LED will flash 5 times and the machine
will beep 3 times and "Fill Tank" will
be displayed in the LCD.
NOTE
If boilers are not empty, the machine
will beep 3 times and the downlights
will flash 5 times and "VALV" will be
displayed in the LCD.
Machine will fill boilers with de-scale
a)
solution and heat to temperature.
20 minute timer will begin. Countdown
b)
timer is finished when PUSH is
displayed on the LCD screen.
(This allows solution to dissolve
scale build up).
Step 4 – Empty de-scale Solution
Empty water tank, rinse and fill water
a)
tank with clean water. Replace tank
into machine.
Ensure drip tray is empty and installed
b)
into position. Place cloth on right side of
the drip tray to stop steam escaping.
22
Rotate left screw first, counter-clockwise
c)
until fully open. Water will begin to flow
into drip tray.
Repeat with right screw. Steam
d)
will be released from the boiler.
CAUTION HOT STEAM!
CAUTION HOT STEAM!
Close valves when water stops
e)
flowing through both outlets. Empty
drip tray and re-assemble onto unit.
CAUTION HOT WATER!
Step 5 – Fill Boilers
Press MANUAL button and the 5 minute
timer will begin. Countdown timer is
finished when PUSH is displayed on the
LCD screen.
(This allows any remaining solution
to be removed from system).
OPERATING yOUR BREvILLE PROdUCT
Step 6 – Flush Boilers
Empty water tank, rinse and assemble
a)
new water filter into tank.
Fill water tank with clean water and
b)
replace into machine.
Rotate screws counter-clockwise, as per
c)
previous instructions until fully open.
Water will begin to flow into drip tray.
Close valves when water stops flowing
d)
through both outlets. Empty drip tray
and re-assemble onto unit. CAUTION
HOT WATER!
Press MANUAL button to complete the
e)
de-scale procedure. Machine will heat
up as normal.
Temperature Unit - ˚C/˚F (SEt)
Temperature Unit will be displayed on the
LCD screen as SEt. Press MENU to Select.
Use UP and DOWN arrows to select desired
temperature unit. Press MENU to set.
Machine will beep once to confirm selection.
Press EXIT to return to STANDBY mode.
Steam Temperature (StEA)
Adjust Steam Temperature to control the
pressure of the steam being delivered.
Lower steam temperature to texture smaller
volumes of milk or have more control. Raise
steam temperature to texture larger volumes
of milk.
Press MENU to Select STEAM.
Use UP and DOWN arrows to select
required steam temperature.
Press MENU to set.
Machine will beep once to confirm selection.
disable CLEAN ME! Alert (A OF)
Use this function to disable the
CLEAN ME! alert that displays after
every 200 extractions.
Use the UP or DOWN arrows to select
Off or On. Press MENU to set.
Machine will beep once to confirm selection.
23