Toshiba PORTEGE R830 Maintenance Manual page 337

4.12 Optical disk drive (DVD-Super Multi drive)/SD board
3. Peel off the double-side tapes (D-tape circle) on the cover assembly.
4. Stick new double-sided tapes (D-tape circle) and peel off the separators.
5. Stand the optical disk drive and set the SD board to the cover assembly in place.
6. Connect the inner harness to the connector CN6070 on the back of the SD board.
7. Secure the SD board with the following screws.
• M2×3B
8. Stick the SD board FPC on the double-sided tapes.
9. Set the optical disk drive in place.
CAUTION: The laser beam goes out when turning on the power of the computer,
because there is no cover on the optical disk drive. The power must be
turned off when you remove or install the optical disk drive.
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880)
S-THIN HEAD
4 Replacement Procedures
×4
[CONFIDENTIAL] 4-43