Table of Contents
Advertisement
I I m m p p o o r r t t a a n n t t : : The Activity monitor will momentarily flash
Red when the receiver acquires a valid signal from the
handheld transmitter. Repeat this procedure as necessary
until the signal reception is confirmed.
9 – Connect the receiver modular cable to
the controller.
10 – Run a basic station operation using the handheld
transmitter to confirm established communications
and proper controller operation.
A A d d j j u u s s t t S S t t a a t t i i o o n n N N u u m m b b e e r r R R a a n n g g e e
When shipped from the factory, the highest station number
that can be selected is 24. To adapt the handheld transmit-
ter for various controller configurations, the station number
range can be easily adjusted from 1 to 512.
1 – Press and hold the
transmitter powers up.
2 – Press and hold the
arrow buttons at the same time.
The current station range value will be
displayed (flashing).
3 – To adjust the value, press the
down arrow button.
button for rapid scrolling. In this example
the station range is reset to 36.
4 – Press and hold the
at the same time to exit
the adjustment mode.
ON button until the
left and
Press and hold the
left and
T T M M R R - - 1 1
S S e e t t u u p p F F e e a a t t u u r r e e s s
right
up or
right arrow buttons
1 1 5 5
Advertisement
Table of Contents
