Table of Contents
Advertisement
A A S S C C O O p p e e r r a a t t i i o o n n
The ASC (All Station Cycle) feature enables all stations
to be automatically operated in numeric sequence for a
two-minute run time.
When ASC operation is initiated, a start command is sent
to station number 1. The station runs for two minutes and
shuts off. All subsequent stations (up to and including the
highest station number accessible on the transmitter) will
run automatically in numeric sequence.
adjust the station number range for this procedure. Refer to
"Adjust Station Number Range" on page 15.
T T h h e e s s t t a a t t i i o o n n r r u u n n t t i i m m e e u u s s e e d d d d u u r r i i n n g g A A S S C C o o p p e e r r a a t t i i o o n n i i s s
f f i i x x e e d d a a t t t t w w o o m m i i n n u u t t e e s s a a n n d d c c a a n n n n o o t t b b e e a a d d j j u u s s t t e e d d . .
1 – Press and hold the
transmitter powers up.
number operated will be displayed.
2 – To select the ASC function, press the
up arrow button one step past the highest
station number, or press the
button one step past the lowest station
number.
rapid scrolling.
3 – Press the
turn on and the timer will begin counting
down from two minutes, in one-second
intervals. Every 15 seconds, the display
will alternate to indicate that an ASC
operation is currently running.
1 1 2 2
ON button until the
Press and hold the button for
ON button.
T T M M R R - - 1 1
You may prefer to
The last station
down arrow
Station 1 will
A A S S C C O O p p e e r r a a t t i i o o n n
Advertisement
Table of Contents
