Table of Contents
Advertisement
T T M M R R - - 1 1 S S e e t t u u p p F F e e a a t t u u r r e e s s
A A b b o o u u t t C C o o m m m m u u n n i i c c a a t t i i o o n n A A d d d d r r e e s s s s C C o o d d e e s s
The handheld transmitter and receiver provided in the
TMR-1 kit are programmed by default with the same
three-digit communication address code ranging from
001 to 999 and requires no additional adjustments for
initial remote control operation.
Due to the long-range capability of the TMR-1 transmitter,
cross talk to more than one receiver is possible if the
receivers are located within the transmitter's broadcast
radius. So, it is generally good practice to assign a unique
address to each receiver when operating multiple remote
control irrigation systems with a single TMR-1 handheld
transmitter.
The transmitter and receiver address codes are
accessed and set through the transmitter keypad.
S S e e t t T T r r a a n n s s m m i i t t t t e e r r t t o o t t h h e e R R e e c c e e i i v v e e r r ' ' s s A A d d d d r r e e s s s s C C o o d d e e
1 – Press and hold the
transmitter powers up.
2 – Press and the
the address setup mode. The current
transmitter address code will be displayed.
3 – Press and hold the
until the word ADDRESS and the third
digit of the address code begin flashing,
then release.
revert to the initial power-up screen after
30 seconds of inactivity.
4 – To adjust the digit, press the
down arrow button. To select another
digit, press the
button.
In this example, the transmitter
is being set to access a receiver address code of 007.
5 – Press the
ON button until the
Address button to access
Address button
The display will automatically
left or
Address button to exit the setup mode.
T T M M R R - - 1 1
up or
right arrow
S S e e t t u u p p F F e e a a t t u u r r e e s s
1 1 3 3
Advertisement
Table of Contents
