Epson D-Jet 500 Installation Manual page 31

Mount the base plate which has two holes to the
right cross section profile.
Use only one M5 x 14 on the side and two M8 x 20
on the top.
Do not fully tighten the screws yet! The base plates
should be movable.
Mount the base plate which has one hole to the left
cross section profile.
Use two M5 x 14 and two M8 x 20.
Do not fully tighten the screws yet! The base plates
should be movable.
DJet 300-500-700 – HW Installation Manual
Frame Assembly
5
Printer Base Plates
set no screw here
her
eDF
GD
SGF
5-15