Checking Driving Shaft Components - PIAGGIO 500 cc Service Manual

- Before assembling the new bearing on the crank-
case transmission side, heat the housing by means
of the specific tool.
Specific tool:
Heater
- Fit a new bearing on the specific tool after having
greased the fitting slot
- Assemble a new bearing on the engine crankcase by
means of the specific tool.
N.B.: If a bearing with a plastic cage is used, position
the balls so that they face the crankcase inner side.
Specific tool:
Punch handle
Adapter 42x47 mm
17 mm guide

Checking driving shaft components.

- Check the connecting rod end play.
Standard play: 0.20 - 0.40 mm
020151Y
020376Y
020359Y
020439Y
Driving shaft crankcase
05_266
05_267
05_268
8 - 9
8