Important Safety Instructions Dear SunBriteTV Customer: Congratulations on your ownership of the SunBriteTV Model 4610HD. This product is designed as a weatherproof LCD television that can be installed outdoors. To ensure safety and minimize mechanical malfunctions of your product, please read the Important Safety Instructions carefully before using this product.
When the TV is not in use, it is important to keep it covered with the SunBriteTV fi tted Outdoor Dust Cover. Use a soft brush or towel to remove snow and ice from the TV. In areas where dust or salt air is prevalent, it is recommended that the fi...
Page 4
However, it is not designed to withstand pressure washers, high-pressure water jets, or hurricane-type weather. Do not service SunBriteTV yourself: Removal of the television screen cover may expose you to high voltage or other dangerous risks. Refer all servicing to a qualifi ed service professional. Warranty will not be honored if you service the unit yourself.
Features Information and Instructions Internal Thermostatically-Controlled Heater Programming Other Manufacturers’ Universal Remote Control Devices SunBriteTV Pixel Quality Policy Appendix A - RS232 Control Codes Appendix B - RS232 Control Cable Pinout SunBriteTV Model 4610HD Operator’s Manual Page 5 Page 5...
Supplied Accessories Unpacking After unpacking the SunBriteTV television, please make sure that the following items are included in the carton and that they are in good condition. If items are damaged or missing, contact your dealer immediately. SunBriteTV LCD Television Model 4610HD Remote Control with Batteries Operator’s Manual...
Speaker Cable Wire should not be placed across the bottom of the Rubber Sealing Gasket (Figure 6). Figure 6 Figure 4 Figure 5 Speaker Connector Thumb Screws Connect Source Cover Rubber Sealing Gasket Speaker Cable Speaker Cable Wire should not come out of this area SunBriteTV Model 4610HD Operator’s Manual Page 7...
Do not attach the Table Stand if you plan to install the TV on a wall mount or ceiling mount. Table Stand b. If you are planning to use the SunBriteTV Model 4600HD Detachable speakers, Mounting Screws you must install the speakers before you attach the Table Stand.
3. Close the cover. 4. Press fi rmly on the cover, and screw the Thumb Screws tightly (Figure 3). Rubber Sealing Gasket Indentations Figure 2 Thumb Screws Figure 1 Figure 3 Page 9 SunBriteTV Model 4610HD Operator’s Manual Page 9...
IR Emitter placed over the IR Window and Appendix B for a Control Cable Pinout Diagram.) 14. 12 VDC - This port is for the SunBriteTV FM Radio (Item SB-FM 461) connector only. Emitter Window: Figure 15 shows an Emitter* installed. One end of the Emitter is to be mounted in front of the IR Cable end that will be attached to an Emitter Window.
Page 11
TV Installation – Rear Panel Connections Cable Descriptions: Connection Descriptions: Blue Green Yellow Green White SunBriteTV Model 4610HD Operator’s Manual Page 11...
Page 12
2. The TV’s tuner is designed for HDTV therefore requires a stronger signal than normal TVs. If you cannot achieve that signal level with your antenna or cable, your 4610HD might lose picture or sound. 3. This TV will turn off automatically if there’s no signal present for more than 15 minutes.
Page 13
3. Use a Coaxial RF cable and connect from your 3. The MODEL 4610HD’s tuner is designed for HDTV therefore VCR’s Antenna Out or Output to TV to the ATSC/ requires a stronger signal than normal TVs. If you cannot achieve NTSC port of your TV.
Page 14
DVD player and Composite’s white connector port off the back of your TV. connector port off the back of your MODEL 4610HD. Connect the red color connector to both your DVD player Connect the red color connector to both your DVD player and Composite’s red connector port off...
Page 15
HDMI 2. Connect the red color connector to both your set-top box and SunBriteTV’s MODEL 4610HD supports SONY’s universal Component 1’s red connector port off the back of your TV to the right side of your green, blue, red component connection.
Page 16
DVD player and Composite’s white connector port off the back of your TV. connector port off the back of your MODEL 4610HD. Connect the red color connector to both your DVD player Connect the red color connector to both your DVD player and Composite’s red connector port off...
Page 17
3. The TV will turn off automatically if there’s no signal present for more than 15 minutes. If HDMI 1 is already occupied, use HDMI 2 as your connection port, and switch source to HDMI 2 SunBriteTV Model 4610HD Operator’s Manual Page 17...
Page 18
TV Installation – Rear Panel Connections CONNECTING TO A PC (Continued) 1. Make sure the power of the TV and your PC is turned off . Connecting with RCA Audio Analog (Good) 2. Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of your PC and the other end to the VGA port off...
Page 19
Refer to the Wii manual to make sure the Wii is confi gured to output correctly to the TV. 4. This TV will turn off automatically if there’s no signal present for more than 15 minutes. SunBriteTV Model 4610HD Operator’s Manual Page 19...
TV Installation--Rear Panel Connections Connecting the Power Cord WARNING: TV AND GFCI RECEPTACLE MUST BE INSTALLED AT LEAST 5 FEET AWAY FROM STANDING WATER , SUCH AS (BUT NOT LIMITED TO) A POOL OR SPA. Connect the power cord after you have made connections to your video equipment. Connect the power cord to a GFCI-protected AC outlet with “in-use”...
If the remote control is used properly, it will give you many years of service. The functionality of the remote control and the long-life lithium batteries are under warranty for one year. If the remote control malfunctions or stops working within the one-year warranty period, SunBriteTV will repair or replace the remote control at SunBriteTV’s option.
1. Clean the window by using the following directions: To clean the SunBriteTV window, use an ammonia-free glass cleaner and a lint-free or micro-fi ber cloth. Spray the solution on the cloth and then apply to the window. DO NOT use acrylic cleaners or ammonia.
Specifi cations Specifi cations for SunBriteTV Model 4610HD Specifi cations Side View Front View LCD Screen 46-inch diagonal TFT Active Matrix Resolution HD 1920 x 1080 Full HD 1080p Aspect Ratio 16:9 Contrast Ratio 2000:1 Viewing Angle Response Time 6 milliseconds...
Your SunBriteTV will be replaced under warranty if it meets one of the following criteria: —A total of 7 defective pixels, including both bright dots and dark dots are present. (Model 4610HD LCD TV screen has over a million pixels.) —2 or more pairs of adjacent bright dots are present.
Com Specs: 9600 baud 8 data, 1 stop, no parity Rx Data Tx Data Ground From control to control system system SunbriteTV RS232 Control Cable SIZE FSCM NO DWG NO July 17 2007 Preliminary 1 OF 1 SCALE SHEET SunBriteTV Model 4610HD Operator’s Manual Page 47...
Need help?
Do you have a question about the 4610HD and is the answer not in the manual?
Questions and answers