Garmin GPS 400W Installation Manual page 85

CHANNEL OUTPUTS
Selection
Off
ADS-B OUT [4]
ADS-B OUT+ [5]
Aviation
Avtn no alt
Crossfill
GDL 69
GDL 88 [5]
GDL 88 WX [5]
GTN Crossfill [5]
HW EGPWS [3]
MapMX [2] [3]
Ryan TCAD
WX-500
[1] The MX20 will not use GPS altitude from the 400W Series unit. The GMX200 will use the GPS
altitude.
[2] Use of the MapMX protocol supports enhanced flight plan depiction and automatic loading of charts
on the MX20 and GMX 200. MapMX is only available with main software version 3.10 or later.
[3] Due to hardware limitations, selecting MapMX or HW EGPWS on an RS-232 output port prevents
anything from being configured on the corresponding input port.
[4] ADS-B OUT is only available with main software version 3.20 or later.
[5] Main software version 5.00 or later.
GNS 400W Series Installation Manual
190-00356-08
Description
No unit(s) connected to output of this channel
Serial communication to Garmin GTX 33/330ES or 33D/330DES
Transponders.
Serial communication to a Garmin GTX 33/330ES or 33D/330DES
transponders.
Serial position, altitude, velocity, and navigation data to the following
units:
Argus 3000, 5000, or 7000 Moving Map
Electronics International FP-5L Fuel Flow Computer (non-TSO'd)
Garmin MX20 (V5.6 or later), GMX 200 [1]
Garmin GPSMAP 195, GPSMAP 295 or GPS III Pilot
Garmin GPSMAP 196, GPSMAP 296, and GPSMAP 396
Garmin GTX 327 Transponder
JP Instruments EDM-700 or EDM-760 Engine Monitor
Shadin 91204XM Digital Fuel Management System
Shadin 91053XM Digital Fuel Management System
Shadin 9628XX-X Fuel/Air Data Computer
Stormscope Series II (with NAVAID) Moving Map
Serial position, velocity, and navigation data to the following units:
Garmin MX20 (V5.5 or earlier)
Horizon DDMP
INSIGHT TAS 1000 Air Data Computer
Serial transfer of flight plans and user waypoints between two
400W/500W Series units
Serial communication to a Garmin GDL 69/69A.
Serial communication to a Garmin GDL 88.
Serial communication to a Garmin GDL 88 plus display of FIS-B
weather information.
Serial transfer of the active flight plan from a Garmin GTN unit to a
GNS unit, and manual transfer of user waypoints between GNS and
GTN units.
Serial communication to a Bendix/King (Honeywell) KGP 560 EGPWS.
Serial position, altitude, velocity, and navigation data to the following
units:
Garmin MX20 (V5.7 or later), GMX 200 [2]
Serial communication with a Ryan TCAD 9900B Series system.
Serial communication to an L3 Communications WX-500 Stormscope.
Page 5-7
Rev. G