Firebox Panel Kit Installation - Superior DRI3030TENC Installation And Operation Manual

Figure 9
1 - PANEL INSTALL: BRACKET REMOVAL
3 - PANELS INSTALLED
Figure 10
14
See Detail B
Detail B
DETAIL B
SCALE 0.500
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Firebox Panel Kit Installation Instructions:
1. Remove the glass door following the instructions provided in this
manual.
2. Remove the two brackets from the firebox using a 5/32" allen wrench
(see Figure 11). Retain the screws for step 4, and discard the brackets
as they will not be needed.
3. Install the rear panel by inserting the tabs on the bottom of each end
into the slots on the rear burner-retaining tray (see Figure 12).
4. Install one side panel by inserting the tab (located on the bottom
edge near the back) into the same slot as one side of the rear panel
(see Figure 12). Fasten in place using one screw from the brackets
removed in step 2. Repeat for the other side panel.
NOTE: The side panels overlap on top of the back panel.
1 - PANEL INSTALL: BRACKET REMOVAL
1 - PANEL INSTALL: BRACKET REMOVAL
Figure 11 - Panel Install: Bracket Removal
3 - PANELS INSTALLED
Figure 12 - Panel Installation
3 - PANELS INSTALLED
Figure 13 - Panels Installed
2 - PANEL INSTALLATION
MEDIA