Removal/Installation Of Glass Doors Barriers And Modesty Panel - Superior DRT63STTEN Installation And Operation Instructions Manual

Innovative Hearth Products
DRT63ST Direct-Vent Gas Fireplaces
REMOVAL AND INSTALLATION OF
GLASS DOORS, BARRIERS AND MOD-
ESTY PANEL
WARNING
HOT GLASS WILL CAUSE bURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
• Install only when fireplace is OFF and
COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace
reaches EXTREMELY HIGH temperatures
and can cause severe burns if touched.
Even after the gas is turned off, fireplace
surfaces remain extremely hot.
CAUTION
RISk OF PERSONAL INJURY
OR PROPERTY DAMAGE.
• Do NOT abuse glass doors by striking or
slamming shut
• Never operate fireplace with glass door
assemblies removed.
These direct-vent appliances are designed
to operate only when both glass door
assemblies are installed. Generally, the
glass door assemblies should not be
removed, except when access to compo-
nents within the firebox is required.
• Securely tighten door latch screws when
reinstalling glass door assemblies to
prevent doors from falling out.
• Handle glass door assemblies with
extreme care. Replace damaged glass
door assemblies with approved replace-
ment assemblies only.
The door assemblies on this fireplace
contain ceramic glass. Handle with care
to prevent damage. If the door frame
or glass on either assembly becomes
damaged, replace the entire glass door
assembly with a manufacturer-approved
replacement assembly only. Do not
attempt to substitute any materials used
on door assemblies or replace cracked
or broken glass with any other materials.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou brisé.
Installing Glass Doors, Barrier, and
Modesty Panel
(see Figure 54)
NOTE: These instructions do NOT apply to the
Outer Glass Door provided in the Outdoor Kit
(for indoor/outdoor installations).
Only doors certified with the appliance shall
be used.
Seules des portes certifiées pour cet appa-
reil doivent être utilisées.
Only barriers certified with the appliance
shall be used.
1) Install one of the glass doors, as follows:
a) Retrieve the glass door. Visually inspect
the gasket on the back of the frame.
Gasket surface must be clean, free of
irregularities, and seated firmly.
b) Position the door in front of the firebox
opening, with the top of the door held
away from the fireplace (see Figure 54).
c) Lower the bottom of the door assembly
onto the bottom door track, engaging and
centering it in the base channel, and then
gently swing the door up.
d) Using a #3 Phillips screwdriver, fasten the
door frame to the door latches with the
two (2) latch screws. The latches should
pull forward to engage the door frame.
NOTE: Securely tighten latch screws when
reinstalling glass door assembly.
2) Install the modesty panel on the top flange
of the glass door, as follows:
a) Grasp the modesty panel with both hands
(with the open hem facing down).
b) Engage it with the top flange of the glass
door frame by pushing it all the way
down. Make sure the installed modesty
panel is firmly in place.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Operation Instructions
900355-01, 07/2015
Removing Glass Doors, Barrier and
Modesty Panel
(see Figure 54)
barrier (see Notice, Page 30) - This fireplace
comes with a barrier to reduce the likelihood
of burns from touching hot glass. If the bar-
rier is damaged, the fireplace should be turned
off immediately and the fireplace must not be
operated until a new, approved factory barrier
for this unit is installed. To remove barrier fol-
low these steps.
1. Lift barrier up by the frame at the top.
2. Remove lower filler piece by pulling down
off of the barrier.
3. Lower barrier and push barrier to left to
release right side.
4. Pull the right side out of fireplace.
5. Remove screen.
6. Install the new, approved factory barrier
with flat side of screen toward firebox.
1) Remove the modesty panel from the top
flange of the glass door by firmly pulling up
on it with both hands until it is disengaged.
2) Remove one of the glass doors, as follows:
a) See Figure 54. While holding the top of
the glass door frame in place, use a #3
Phillips screwdriver to remove the two
(2) screws securing the door frame to
the two (2) door latches.
b) Carefully tilt the top of the glass door
frame away from the unit (as shown in
Figure 54), and then lift the door as-
sembly up and out of the lower track.
c) Carefully place the glass door assembly
on a padded surface in a safe location to
prevent damage.
Top Flange
on Glass door assembly
Glass Door Latch (2)
Screws
Glass Door
Figure 54
41