Table of Contents
Advertisement
Zero Clearance Fireplace Installation
This appliance may be installed in a masonry or factory built/zero clear-
ance (ZC) fireplace. When installing in a ZC fireplace, the ZC grate must
be removed and the ZC damper must be removed or secured open. The
ZC doors, screen, refractory or masonry lining, baffles and smoke shelf
may be removed if necessary to install the gas insert. However, do not cut
or alter the fireplace components. The removal of any parts to facilitate
installation must not alter the integrity of the inner or outer shells of the
fireplace cabinet. Any parts removed must be replaceable if the insert is
taken out of the fireplace or the fireplace clearly marked with a paint stick
that "This fireplace has been altered and is no longer safe to operate."
This appliance is designed to fit into a ZC fireplace with a minimum firebox
height of 19-1/2" (495mm).
If the factory-built fireplace has no gas access hole(s) provided, an ac-
cess hole of 1-1/2" (37.5 mm) or less may be drilled through the lower
sides or bottom of the firebox in a proper workmanship like manner. This
access hole must be plugged with a non-combustible insulation after the
gas supply line has been installed.
Si le foyer préfabriqué ne comporte pas d'orifices d'amenée du gaz, un
orifice d'au plus 37,5 mm (1,5 po) peut être pratiqué, selon les règles
de l'art, dans la partie inférieure des parois ou au fond de la chambre de
combustion. Cet orifice doit être obturé au moyen d'isolant incombustible
une fois la conduite de gaz en place.
The installer must mechanically attach the marking supplied with the gas
fireplace insert to the inside of the firebox of the fireplace into which the
gas fireplace insert is installed. See Figure 1 on Page 6.
Glass Door
• Do not attempt to substitute the materials used on
these doors, or replace cracked or broken glass.
• Handle this glass with extreme care! Glass is
susceptible to damage – Do not scratch or handle
roughly while reinstalling the glass door frame.
• The glass door(s) of this appliance must only be
replaced as a complete unit as provided by the
manufacturer. Do not attempt to replace broken,
cracked or chipped glass separately.
• Do not attempt to touch the front enclosure glass
with your hands while the appliance is in use.
• Do not use abrasive cleaners. Never clean the
glass when it is hot.
WARNING
Do not operate the appliance with the glass front
removed, cracked or broken.
WARNING
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
AVERTISSEMENT
Ne pas utiliser l'appareil si le panneau frontal en
verre n'est pas en place, est craqué ou brisé.
Only doors certified with the appliance shall be used.
Seules des portes certifiées pour cet appareil doivent être
utilisées.
CAUTION: DO NOT abuse glass door by striking or slamming shut.
Do not remove glass door while the appliance is hot.
Glass Door Removal
To remove the glass door:
1. Pull latches on the bottom right and left of the door out of the slots
and place below the tab on the front door.
2. The door can now be pulled from the bottom away from the firebox
and lifted up and off the firebox.
3. To reinstall the door, complete the steps in reverse order.
See Detail A
Figure 8
Detail A
DETAIL A
13
Advertisement
Table of Contents
