Using Diagnostics - Motorola DCT2500 Installation Manual

A-2 Diagnostics

Using Diagnostics

To operate the set-top, use the Motorola universal remote control. To access and navigate the
diagnostic mode:
Press on the remote control to turn on the set-top.
1
POWER
Wait five seconds and then press
2
To enable diagnostic mode, press
3
powering off. The DIAGNOSTICS main menu is displayed on the OSD:
DIAGNOSTICS
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
Use the keys on the remote control to select the desired diagnostic.
4
CHANNEL
Press <,
5
CURSOR CURSOR
To exit the diagnostic mode, press
6
diagnostic mode and powers off.
DCT2500 Installation Manual
again to turn off the set-top.
POWER
/ on the remote control within two seconds after
SELECT OK
GENERAL STATUS
OOB STATUS
IN BAND STATUS
AUDIO/VIDEO STATUS
UNIT ADDRESS
FIRMWARE VERSION
CURRENT CHANNEL STATUS
RENEWABLE SECURITY
UPSTREAM MODEM
APP CODE MODULES
MEMORY CONFIG
INTERACTIVE INFO
MAC FREQUENCY TABLE
CONTROL CHANNELS
MESSAGE TYPES
IN BAND PAT
IN BAND PMT
TASK STATUS
USB STATUS
IB MCA STATUS
KEYBOARD / LED
>, , or
SELECT ENTER
on the remote control. The set-top exits the
POWER
to run the selected diagnostic.