Cisco Unified Ip Conference Phone 8831 Installation Overview - Cisco 8831 Installation Manual

Cisco Unified IP Conference Phone 8831 Installation
Set Wireless Microphone Region
Procedure
Step 1
In Cisco Unified Communications Manager Administration, go to Device > Phone.
Step 2 Use the Find capability to find the Cisco Unified IP Conference Phone 8831.
Step 3 In the Product Specific Configuration Layout area of the Phone Configuration window, change the Wireless
Microphone Region setting to the region where the device is located. The drop-down list box lists the available
regions.
Safety
Review the following warnings before installing the conference station. To see translations of these warnings,
see the Regulatory Compliance and Safety Information for Cisco Unified IP Conference Stations document
that accompanied this device.
Read the installation instructions before you connect the system to its power source.
Attention
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Attention
Ultimate disposal of this product should be handled according to all national laws and regulations.
Attention
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Attention
To avoid electric shock, do not connect safety extra low voltage (SELV) circuits to teleconference station
Caution
network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits.
Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
The following warnings apply when you use an external power supply.
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that a
Attention
fuse or circuit breaker no larger than 120 VAC, 15 A U.S. (240 VAC, 10 A international) is used on the
phase conductors (all current-carrying conductors
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
Safety
3