Table of Contents
Advertisement
SERVICE MANUAL
Model: HBCW100ABB/HVFE040BBB
Chapter 3 Installation, adjustments and maintenance
3-1. Installation
3-1-1.Unpacking the Unit:
Remove all packaging material. This includes the foam base and all adhesive tape holding the
Unit accessories inside and outside, compressor from shipping damage due to vibration and
shock.
Inspect and remove any remains of packing, tape or printed materials before powering on the
Unit.
3-1-2.Leveling the Unit:
The Unit has four leveling legs which are located in the front and rear corners of the Unit. After
properly placing the Unit in its final position, you can level the Unit.
Leveling cellar or by turning them clockwise to lower the unit, the unit door will close easier when
the leveling legs are extended.
Proper Air Circulation
1. To assure the unit works at the maximum efficiency it was designed for, you should install it in
a location where there is proper air circulation, plumbing and electrical connections.
2. The following are recommended clearances around the unit:
Sides..............2" (50mm)
Top ................2" (50mm)
Back..............2" (50mm)
3. Do not over fill the unit for proper internal air circulation.
3-1-3.Electrical Requirement
Make sure there is a suitable power outlet (115~V) with proper grounding to power the unit.
Avoid the use of three plug adapters or cutting off the third grounding in order to accommodate a
two plug outlet, this is a dangerous practice since it provides no effective grounding for the unit
and may result in shock hazard.
3-1-4.Install Limitations
Do not install the unit in any location not properly insulated or heated e.g. garage etc, the unit was
not designed to operate in temperature settings below 55
Select a suitable location for the unit on a hard even surface away from direct sunlight or heat
source e.g. radiators, baseboard heaters, cooking appliances etc, any floor unevenness should
be corrected with the leveling legs located on the front and rear bottom corners of the unit.
The unit is designed for free-standing installation only; it is not designed for built-in application.
Issue 2011-10-21
Rev.
Ref1110S003V0
Fahrenheit.
8
Advertisement
Table of Contents
