Messages On The Unit's Display - Panasonic Diga DMR-BCT820 Operating Instructions Manual

Troubleshooting
Troubleshooting guide

Messages on the unit's display

The following messages or service numbers
appear on the unit's display when something
unusual is detected.
BD
("∑" stands for a number.)
The remote control and main unit are using
different codes. Change the code on the remote
control. ( 106)
CAM-UP
CAM is being updated. (
CONV
Selected titles in the USB HDD are being
converted.
Do not disconnect the USB HDD from this unit.
GUIDE
TV Guide data is being downloaded.
HARD ERR
If there is no change after switching the unit to
standby mode and turning it on, consult the
dealer.
NoERAS
You cannot delete items on this disc.
The disc may be damaged.
NoREAD
• The disc is dirty. ( 10) The unit cannot record,
play, or edit.
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to
eject the disc.
112
VQT4G51
103)
NoWRIT
You cannot write to this disc.
The disc may be damaged. Use a new disc.
PLEASE WAIT
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
PROG FULL
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
REMOVE
The USB device is drawing too much power.
Remove the USB device.
START
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. ( 102)
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
UNSUPPORT
The media is not supported.
UPD /
("∑" stands for a number.)
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. ( 102)
38)
102)