Panasonic Diga DMR-BCT820 Operating Instructions Manual page 100

Convenient functions
Changing the unit's settings (Setup)
Automatic Standby after Copy
• On:
This unit is turned to standby mode when it
is not operated for approximately 5 minutes
after completing copy (
media other than HDD with DIRECT
NAVIGATOR, Copying titles with copying
list).
RF OUT ( CATV Signal )
Set whether to output the broadcasting signal
from RF OUT or not while in standby mode
(When "Power Save in Standby" is activated).
• If "On" is selected, the broadcasting signal
is output from this unit.
Remote Control
Change the remote control code on the main unit
and the remote control if you place other
Panasonic products close together.
• Use "BD 1", the factory set code, under normal
circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the
number button ([1] to [6]) for more than
5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
• Operation is possible only with Panasonic
remote controls with "IR6" printed at the bottom
when the remote control code of this unit is set
to "BD 4", "BD 5" or "BD 6".
BLU-RAY DISC RECORDER
IR6
100
VQT4G51
Clock
If the time is not set correctly, use the settings
listed in the method below.
• Automatic
56, Copying from
• Time Zone
• Manual Setting
PIN Entry
You can set/change the PIN for parental control.
1 Enter your 4-digit PIN with the number
2 Enter the new 4-digit PIN with the number
3 Press [OK].
System Update
IR6
IR6
This unit usually obtains time and date
information from digital broadcasts.
When the time is not correct, set "Time Zone".
(GMT - 6 to + 6)
1 Select "Off" of "Automatic", then press [OK].
2 Select the item you want to change.
3 Change the setting.
4 Press [OK] when you have finished the
settings.
• When the clock is set manually, you cannot perform
playing/recording/PAUSE LIVE TV/REWIND LIVE TV of
the programmes that are copy protected (Copying is
prohibited). ( 15)
buttons.
buttons.
• Make a note of PIN in case you forget it.
e.g.,
PIN Entry
Remember the PIN.
0 0 0
OK
Software Update in Standby
When you set this unit to standby mode,
software (firmware) updates (
downloaded automatically at the time you
have specified.
0
102) are