Software (Firmware) Update; Update Software (Firmware) Of This Unit - Panasonic Diga DMR-BCT820 Operating Instructions Manual

Convenient functions

Software (Firmware) Update

You cannot operate the unit until the update
is complete. Don't remove the AC mains lead
during the update. Removing the AC mains
lead while the update is in progress may
damage the unit.

Update software (firmware) of this unit

When this unit is connected to the Internet, the
unit can automatically check for the latest
software (firmware) version when switched to
standby mode.
We recommend that you always connect this unit
to the Internet. ( 20, 24)
If a software (firmware) update is available, a
notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
Update of the software (firmware) will start when
the unit is turned to standby mode.
To update the software (firmware)
immediately
Use the "Software Update Now ( Internet )"
function. ( 101)
• Network connection and setting are required.
( 20, 24)
The unit's display during the update
e.g.,
• When "FINISH" is displayed, update of the
software (firmware) has completed.
102
VQT4G51
If your unit is not connected to the Internet
You can download the latest software (firmware)
version from the Panasonic support site below.
After you copy the latest software (firmware) to a
CD-R disc, play the disc in the unit and it will
automatically update the software (firmware).
• It may take up to a few hours until the update is completed
depending on the network environment.
• The timer recording always takes preference over the
software (firmware) download; if the timer recording is
scheduled to start, the downloading will be performed at the
next opportunity.
• For the latest firmware update information, please refer to
the Panasonic support site below.
Panasonic support site:
http://panasonic.jp/support/global/cs/