Table of Contents
Advertisement
2
Making/Answering Calls
n 1
Back side
one
Speaker
TALK Indicator
Microphone
(REDIAL/PAUSE/PROGRAM)
o
≥For best operating performance, see
section 5-B.
Lighted handset keypad
The handset dialing buttons will light
when you press a button or lift the
handset off the base unit, and flash
when a call is received. The lights will go
out a few seconds after pressing a
ate
button, lifting the handset, answering a
call, hanging up a call or leaving the
programming mode.
3
Speed Dialer
TALK Indicator
(REDIAL/PAUSE/PROGRAM)
2-A Making Calls
(–––)
1
Press
and dial a phone number.
OR
To have a hands-free phone conversation,
(–––)
press
and dial a phone number. When the
other party answers, talk into the microphone.
≥The TALK indicator lights.
≥If an alarm tone sounds, see section 5-E.
2
To hang up,
(OFF)
(OFF)
press
unit.
(‹), (›),
CH (fi)
≥The TALK indicator light goes out.
(HOLD)
To redial the last number dialed
(–––)
(–––)
Press
or
To put a call on hold
(HOLD)
Press
.
≥The TALK indicator on the handset and the
IN USE/CHARGE/HOLD indicator on the base unit
flash.
≥If you put a call on hold for more than 6 minutes, an
alarm tone will sound. The call will be disconnected
after a total of 10 minutes.
To release the hold
(–––)
(–––)
Press
or
, or lift the handset off the base
unit.
≥If another phone is connected on the same line
(5-D), you can also release the hold by lifting its
handset.
3-A Storing Phone Numbers in Memory
You can store up to 10 phone numbers in the handset. The dialing buttons (
stations. The TALK indicator light must be off before programming.
(REDIAL/PAUSE/PROGRAM)
1
Press
≥The TALK indicator flashes.
2
Enter a phone number up to 22 digits.
(OFF)
3
Press AUTO
AUTO (fl)
4
Press a memory station number (
Memory
Station
≥A beep sounds.
Numbers
≥To store other numbers, repeat steps 1 through 4.
≥If a pause is required for dialing, press
(REDIAL/PAUSE/PROGRAM)
Pressing
or place the handset on the base
¤
(REDIAL/PAUSE/PROGRAM)
.
.
(fl)
.
(0)
(9)
to
(REDIAL/PAUSE/PROGRAM)
counts as one digit (4-D).
Hands-free Digital Duplex Speakerphone
For best performance, please note the
following:
≥Talk alternately with the caller in a quiet
room.
≥If the other party has difficulty hearing you,
(›)
press
to decrease the speaker volume.
≥If the other party's voice from the speaker
cuts in/out during a conversation, press
(›)
to decrease the speaker volume.
(–––)
≥While talking using
, you can switch to
the hands-free phone conversation by
(–––)
pressing
. To switch back to the
(–––)
receiver, press
.
To adjust the receiver volume
(HIGH, MEDIUM or LOW) or speaker
volume (6 levels) while talking
(‹)
(›)
Press
or
while talking.
Receiver volume
(While using
(‹)
(›)
≥Each time you press
or
, the volume level
will change from MEDIUM (preset) to HIGH or
LOW.
≥When you replace the battery, the selected
receiver volume setting will return to the factory
set (MEDIUM). Reprogram if necessary.
Speaker volume
(While using
(‹)
(›)
≥Each time you press
or
, the volume level
will change from level 1 to level 6. Your phone
comes from the factory set to level 3.
If noise interferes with the
conversation
(fi)
Press CH
to select a clearer channel or move
closer to the base unit.
(0)
(9)
to
) function as memory
If you misdial
to end storing. ¤ Start again
(OFF)
Press
from step 1.
To erase a stored number
(REDIAL/PAUSE/PROGRAM)
Press
¤ AUTO
¤ the memory station
(fl)
(0)
(9)
number (
to
) for the phone number to
).
be erased.
≥A beep sounds.
where needed.
"
Ma
(–––)
)
(–––)
)
"
Sp
¤
Advertisement
Table of Contents
