Hitachi CR 13V2 Technical Data And Service Manual page 21

Blade Holder (C) [5]
Lever (C) [22]
Holder Pin (B) [19]
Blade Holder (C) [5]
6. Other
When reinserting the Armature [37] into the Housing [43], observe the following precaution:
With the Armature [37] removed from the Housing [43], the Armature [37] may be extracted from the Ball
Bearing 6001VVCMPS2L [35]. Therefore, be sure to press-fit the Armature [37] into the Ball Bearing
6001VVCMPS2L [35] before reinserting the Armature [37] into the Housing [43] (see Fig. 7).
Ensure that the Cord Clip [59] is properly oriented (see Fig. 20).
Fig. 20
Cord dia.: More than 6.4 mm to 8.5 mm
Blade Spring [23]
Fig. 17
Spring (B) [20]
Cap [18]
Lever (C) [22]
Tapping Screw
(W/Flange)
D4 x 16 [58]
Cord Clip [59]
Plunger (F) [12]
Spring (B) [20]
Holder Pin (B) [19]
Fig. 18
Lock Nut M5 [11]
Plunger (F) [12]
Blade Spring [23]
Special Bolt M5 [21]
Fig. 19
Cord dia.: More than 8.5 mm to 10.8 mm
-18-