Hitachi CR 13V2 Technical Data And Service Manual page 14

Next, use your fingers to extract the rubber Cap [18] sideways from the Lever (C) [22]. Remove the Special
Bolt M5 [21]. The Blade Holder (C) [5], Lever (C) [22], Blade Spring [23], Holder Pin (B) [19], and Spring
(B) [20] can now be removed from the Plunger (F) [12].
Be careful not to lose or damage the Spring (B) [20].
Fig. 3
Holder Pin (B) [19]
Cap [18]
Remove the Plunger (F) [12] from the Gear Cover (F) [4], and then remove the Connector Pin (F) [13] and
two Swing Rollers [14].
Be careful not to damage the Felt Washer [6], V-Ring [8], and O-Ring [9].
Fig. 4
As the Metal (B) [10] is press-fit into the Gear Cover (F) [4], use a press or similar tool to push it out of
position. Then remove the V-Ring [8], Washer (H) [7], and Felt Washer [6]. Use a thin flat-blade
screwdriver or similar tool to remove the O-Ring [9] inside the Metal (B) [10]. Then remove the three Nylock
Bolts (W/Flange) M4 x 12 [25] and remove the Ball Bearing 6002DDCMPS2L [24].
Plunger (F) [12]
Blade Holder (C) [5]
Spring (B) [20]
Blade Spring [23]
Lever [22]
Special Bolt M5 [21]
Gear Cover (F) [4]
Lock Nut M5 [11]
Gear Cover (F) [4]
Connector Pin (F) [13]
Swing Roller [14]
Ball Bearing 6002DDCMPS2L [24]
Nylock Bolts (W/Flange) M4 x 12 [25]
Felt Washer [6]
Washer (H) [7]
V-Ring [8]
O-Ring [9]
-11-
Sub Shaft (B) [26]
Metal (B) [10]