Fisher & Paykel OVER THE RANGE convection MICROWAVE OVEN Installation Instructions Manual page 5

c. Vertical Exhaust: Outside Ventilation
1. Remove and save the 4 screws from the Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the
opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 12.
2. Lift the Hood Fan Unit carefully and slip wires out of cavity. See Figure 13.
CAUTION: Do not pull or stretch hood fan wiring.
3 Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. Note, you will
need to lift the wire over the hood fan unit so the wire will clear. See Figure 14 (A). Then rotate the Hood Fan
Unit 90˚ so that the fan blade openings are facing the top of the oven. See Figure 14 (B). Replace Hood Fan
Unit into the oven. Be careful not to pinch the lead wire between the inner bracket and the Hood Fan Unit. Put
the lead wire into Wire Box. See Figure 14 (C).
4. Replace the Fan Cover Bracket. Make sure the fan blades are visible through the top openings in the oven
before proceeding.
5. Attach the Fan Cover Bracket to unit with the 4 screws removed in step 1 above. See Figure 15. The Hood Fan
Unit is now rotated for vertical exhaust operation.
6. Attach the Exhaust Damper Assembly to the fan cover on the top of the outercase cabinet by sliding it
into the slits in the same direction as the arrow. Use 1 Tapping Screw 4 x 12 mm from the INSTALLATION
HARDWARE and tighten into place. See Figure 16.
Fan Cover Bracket
(B)
Figure 12
(A) Rotate 180˚
(C)
Figure 14
Wire Box
Exhaust Damper Assembly
Figure 16
Figure 13
Figure 15
5