Installation (In-Dash Mounting) - JVC KD-G814 Instructions Manual

KD-G814
Installation/Connection Manual
GET0306-002A
[UI]
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC
car audio dealers.
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
A / B
Hard case/Control panel
G H
Lock nut (M5) Mounting bolt (M5 x 20 mm)

INSTALLATION (IN-DASH MOUNTING)

The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualifi ed technician.
Removing the receiver
Before removing the receiver, release the rear section.
Caution when installing
Fit the receiver into the mounting sleeve by using four corners of the trim plate.
• DO NOT press the panel (shaded in the illustration).
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
C
Sleeve
1
* When you stand the receiver, be
careful not to damage the fuse on
the rear.
Insert the two
handles, then pull
them as illustrated
so that the
receiver can be
removed.
D
Trim plate
I J
Rubber cushion Handles
Fit the protusions outside
the receiver.
When using the optional stay
Stay (option)
Fire wall
Dashboard
Screw (option)
Install the receiver
at an angle of less
than 30˚.
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise,
the receiver will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the
speaker wiring in your car.
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?
• Receiver becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• This receiver does not work at all.
* Have you reset your receiver?
1
E
Power cord
K
Remote controller
Do the required electrical connections.
Bend the appropriate tabs to hold
the sleeve fi rmly in place.
When installing the receiver without using the
sleeve
In a Toyota for example, fi rst remove the car radio and install
the receiver in its place.
2
* Not included for this receiver.
Flat type screws
* 2
(M5 x 8 mm)
Bracket*
Pocket
Bracket
Note : When installing the receiver on the mounting
bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the
receiver.
0105DTSMDTJEIN
EN
F
Washer (ø5)
L
Battery
Flat type screws
2
*
(M5 x 8 mm)
2
*